#Netathlon serial number install#
#Netathlon serial number manual#
#Netathlon serial number pro#

This process is always required if minimum resistance is desired. It takes 10 strokes to fill the central (storage) tank, leaving a minimal amount of water in the outer (active) tank. To achieve minimum resistance, select “MIN” on the tank adjuster. Your new Rowing Ergometer can adapt – at the turn of a dial – to the resistance preferred by each user in the home environment.

Water is moved between the “storage” and “active” chambers of the AR Tank. The Adjustable Resistance (AR) Tank, developed and patented by First Degree Fitness, offers a true multi-level experience.

#Netathlon serial number pro#

Details regarding can be found in the Computer section of this manual.Ĭhoose a flat, level surface on which to use your Apollo PRO Rower, to avoid rocking and potential premature wear.

#Netathlon serial number install#

Install supplied 2x AA Duracell batteries and check computer function. The Apollo PRO frame can be polished with any high grade furniture polish to further highlight the rich luster of the wood finish. Do this at the end of the first month of use and again after eve-ry 12 months Choose a suitable location when standing the product for storage. Note: The Apollo PRO frame bolts require periodic checking for tightness. Check runners for debris prior to each use and clean regularly. Small ob-jects captured between the seat rollers and run-ners can damage the wheels or running surface. Lower the Apollo PRO back to the Horizontal po-sition and test for proper bungee recoil.Ĭheck Seat Rollers/running boards for dirt or de-bris before sitting on the rower seat. Once the Bungee cord is attached to the Rear Brace, tighten the bolts holding the Footboard, the Mainframe to Side Rail Bolts as they are easi-er to access from the vertical position. Note Clean wheels and tracks weekly with a soft dry cloth in order to decrease the rate of wear on both wheels and track. You can tighten these bolts completely once the rower is standing in the vertical position so for the moment, simply align and loosely thread lower bolts/nuts.

You may find that the lower bracket bolts can be difficult to access. You will need 8x M8x45mm Bolts, 16x M8 Washers, 8x M8 Standard Nuts and 8x M8 Nylock Nuts. Next, install the Mainframe onto the Side Rail Assembly as shown.

Note: One washer on outside and one washer on the inside of the side rail.ĭo not over tighten the Transport Wheel Axle as it may inhibit Transport Wheel rotation. Once the Rear Brace and Side Rails are assembled, mount the Transport Wheel Assembly onto the Left/Right Side Rails. Tip: Bumpstops facing inside of rail for correct assembly orientation. Next, connect the Side Rail Left and Side Rail Right using 4x M6x15mm Bolts and Rear Brace. Note the orientation of the Brace and hook must be correct in order to hold the end of the Bungee Shock Cord as depicted by the arrow in the illustration, which points toward the front of rower. From the hardware kit, take the Bungee Hook Mount and install it onto the Rear Brace as shown. Start with the Rear Brace and on the underside you will find a pre-installed bolt.

#Netathlon serial number manual#

Owners Manual Side Rail/Rear Brace/Transport Wheel Assembly